Bluetooth Smart built-in
The wireless solution to set-up, monitor, update and synchronise SmartSolar Charge Controllers.
Ultrafast Maximum Power Point Tracking (MPPT)
Especially in case of a clouded sky, when light intensity is changing continuously, an ultra-fast MPPT controller will improve energy harvest by up to 30% compared to PWM charge controllers and by up to 10% compared to slower MPPT controllers.
Advanced Maximum Power Point Detection in case of partial shading conditions
If partial shading occurs, two or more maximum power points may be present on the power-voltage curve.
Conventional MPPTs tend to lock to a local MPP, which may not be the optimum MPP.
The innovative BlueSolar algorithm will always maximize energy harvest by locking to the optimum MPP.
Outstanding conversion efficiency
No cooling fan. Maximum efficiency exceeds 98%.
The full output current up to 40°C (104°F).
Flexible charge algorithm
Fully programmable charge algorithm (see the software page on our website), and eight pre-programmed algorithms, selectable with a rotary switch (see manual for details).
Extensive electronic protection
Over-temperature protection and power derating when temperature is high.
PV short circuit and PV reverse polarity protection.
PV reverse current protection.
Internal temperature sensor
Compensates absorption and float charge voltage for temperature.
|Battery Voltage||12/24V Auto Select|
|Charge voltage ‘absorption’||Default setting: 14.4V / 28.8V (adjustable)|
|Charge voltage ‘equalization’*||Default setting: 16.2V / 28.8V (adjustable)|
|Charge voltage ‘float’||Default setting: 13.8V / 27.6V (adjustable)|
multi-stage adaptive (eight preprogrammed algorithms) or user defined algrithm
|Temperature compensation||-16 mV / °C resp. -32 mV / °C|
Battery reverse polarity (fuse, not user accessible) Output short circuit, Over temperature
|Operating temperature||-30 to +60°C (full rated output up to 40°C)|
|Power terminals||16 mm² / AWG6|
IP43 (electronic components), IP22 (connection area)
If more PV power is connected, the controller will limit input power.
The PV voltage must exceed Vbat + 5V for the controller to start. Thereafter the minimum PV voltage is Vbat + 1V.
A higher short circuit current may damage the controller in case of reverse polarity connection of the PV array.
*Default setting: OFF